Browse
- No file added yet -

# The dynamic resistance of YBCO coated conductor wire: Effect of DC current magnitude and applied field orientation

journal contribution
posted on 2021-03-29, 02:46 authored by, W Zhou, Q Li, M Yao, J Fang, N Amemiya
Dynamic resistance, which occurs when a HTS coated conductor carries a DC current under an AC magnetic field, can have critical implications for the design of HTS machines. Here, we report measurements of dynamic resistance in a commercially available SuperPower 4 mm-wide YBCO coated conductor, carrying a DC current under an applied AC magnetic field of arbitrary orientation. The reduced DC current, I t/I c0, ranged from 0.01 to 0.9, where I t is the DC current level and I c0 is the self-field critical current of the conductor. The field angle (the angle between the magnetic field and the normal vector of the conductor wide-face) was varied between 0° and 90° at intervals of 10°. We show that the effective width of the conductor under study is ∼12% less than the physical wire width, and we attribute this difference to edge damage of the wire during or after manufacture. We then examine the measured dynamic resistance of this wire under perpendicular applied fields at very low DC current levels. In this regime we find that the threshold field, B th, of the conductor is well described by the nonlinear equation of Mikitik and Brandt. However, this model consistently underestimates the threshold field at higher current levels. As such, the dynamic resistance in a coated conductor under perpendicular magnetic fields is best described using two different equations for each of the low and high DC current regimes, respectively. At low DC currents where I t/I c0 ≤ 0.1, the nonlinear relationship of Mikitik and Brandt provides the closest agreement with experimental data. However, in the higher current regime where I t/I c0 ≥ 0.2, closer agreement is obtained using a simple linear expression which assumes a current-independent penetration field. We further show that for the conductor studied here, the measured dynamic resistance at different field angles is dominated by the perpendicular magnetic field component, with negligible contribution from the parallel component. Our findings now enable the dynamic resistance of a single conductor to be analytically determined for a very wide range of DC currents and at all applied field angles. This is the Accepted Manuscript version of an article accepted for publication in 'Superconductor Science and Technology'. IOP Publishing Ltd is not responsible for any errors or omissions in this version of the manuscript or any version derived from it. The Version of Record is available online at https://doi.org/10.1088/1361-6668/aaa49e.

## Preferred citation

Jiang, Z., Zhou, W., Li, Q., Yao, M., Fang, J., Amemiya, N. & Bumby, C. W. (2018). The dynamic resistance of YBCO coated conductor wire: Effect of DC current magnitude and applied field orientation. Superconductor Science and Technology, 31(3), 035002-035002. https://doi.org/10.1088/1361-6668/aaa49e

## Journal title

Superconductor Science and Technology

31

3

2018-01-23

035002-035002

IOP Publishing

Published

Article

2018-01-23

0953-2048

1361-6668

ARTN 035002

en

## Exports

RefWorks
BibTeX
Ref. manager
Endnote
DataCite
NLM
DC
figshare. credit for all your research.